How Do I Remove Any Fibers Left On The Surface Of My Sculpture?

The best way is with an ordinary little propane torch. Pass the flame quickly over the sculpture for a few seconds and they will flash off. *Do not over heat your finished sculpture*. 

Use just enough flame to remove any 'hairs'. Do so in a well ventilated room and avoid breathing any fumes by wearing a dust mask.

To achieve a smooth and polished surface, the sculpture will need a full 28 day cure. At this point the surface can be burned with a propane torch, and sanded from 350 grit up to 2000 grit. The density/strength/cure of the Pal Tiya Premium has to be completed.